Aluminum veneer is one of the commonly used modern architectural decorative plates, with light weight, good steel, high strength, durability and corrosion resistance, not easy to sully, easy to clean maintenance, installation and construction is convenient and fast.

Aluminum veneer installation, aluminum veneer joint design is not how you want to how, the specific requirements are very professional, so in the installation of aluminum veneer is to understand clearly. The following aluminum veneer manufacturers simply take you to understand the aluminum veneer installation plate joint design requirements:

Aluminum veneer installation of the common form of three, respectively, is open seam, glue, plug tape, etc., but not limited to the three. The specific layout of the aluminum curtain wall panel joint also depends on the specific situation, so the aluminum curtain wall partition will affect its installation effect.

First of all, the width of the board seam is mainly affected by visual effects, installation process, sealing requirements and other factors. Visually, the width of the seams must be consistent or similar to the architectural style. The width of the joint is usually between 8mm and 18mm. If it is too small, it will be difficult to install and tear the sealant due to insufficient expansion. If it is too large, the amount of glue will increase and it is easy to bubble.

Secondly, the depth of the plate seam is generally greater than the length of the aluminum plate, but also a reasonable design. When the seam is shallow, consider whether it meets the minimum thickness required by the specification and whether the tape can be installed. When the seam is deep, consider the operating range of the mounting tool. Specific circumstance should inspect the form of installation, condition to decide.

Finally, interference factors, installation sequence, installation tools and process should also be taken into consideration in the design of plate joints.

In addition, if the building curtain wall is an outdoor enclosure function, it must be required to have a certain displacement capacity, so as to effectively reduce the bad calculation when the building moves. Therefore, the splicing between the aluminum veneer plates of the curtain wall must be handled by split joints. The aluminum veneer facade is broken into independent plates at the split joints without affecting each other, and each piece is installed separately.